July 2010 30 – 629
MP7461.x Reserved 340 422-10,
340 480-10
PLC
RUN
CN123
MP7470 Maximum contouring tool feed rate at 100% override
Input: 0 to 300 000 [mm/min]
0: No limitation
PLC
RUN
CN123
MP7471 Maximum velocity of the principal axes during compensating movements through
M128 or TCPM
Input: 0 to 300 000 [mm/min]
PLC
RUN
CN123
MP7475 Reference for datum table
Input: 0: Reference is workpiece datum
1: Reference is machine datum (MP960.x)
PLC
RUN
CN123
MP7480 Output of the tool or pocket number PLC
RUN
MP7480.0 With TOOL CALL block
Input: 0: No output
1: Tool number output only when tool number changes
2: Tool number output for every TOOL CALL block
3: Pocket number and tool number output only when tool number changes
4: Output of the pocket number and tool number for every TOOL CALL block
5: Pocket number and tool number output only when tool number changes. Pocket table
is not changed.
6: Pocket number and tool number output for every TOOL CALL block. Pocket table is
not changed.
MP7480.1 With TOOL DEF block
Input: 0: No output
1: Tool number output only when tool number changes
2: Tool number output for every TOOL DEF block
3: Pocket number and tool number output only when tool number changes
4: Pocket number and tool number output for every TOOL DEF block
MP Function and input SW version
and
behavior
To Next Page
Loading...
