HEIDENHAIN MANUALPLUS 620 - Page 433

HEIDENHAIN MANUALplus 620 433
5.8 Example Program
N 169 T6
N 170 G197 S800 M103
N 171 M8
N 172 G147 K2
N 173 G73 ID“Hole_1 M6“ F1 [Tapping, first pattern]
N 174 G47 M9
N 175 END_OF_UNIT
N 176 UNIT ID“G73_ICP_Y“ [ICP tapping in Y axis]
N 178 T6
N 179 G197 S800 M103
N 180 M8
N 181 G147 K2
N 182 G73 ID“Hole_2 M6“ F1 [Tapping, second pattern]
N 183 G47 M9
N 184 G14 Q0 D1
N 185 END_OF_UNIT
N 186 UNIT ID“C_AXIS_OFF“ [C axis off]
N 188 M15
N 189 END_OF_UNIT
N 190 UNIT ID“END“ [Program end]
N 192 M30
N 193 END_OF_UNIT
END