To Next Page

To Previous Page

Oponal: Click Copy to , and then select the door to copy the parameters in the page to the

selected doors.

Note

The door's status duraon sengs will be copied to the selected door as well.

Congure Parameters for Card Reader

Aer adding the access control device, you can congure its card reader parameters.

Steps

1. Click Access Control → Advanced

Funcon → Device Parameter .

2. In the device list on the le, click to expand the door, select a card reader and you can edit

the card reader's parameters on the right.

3. Edit the card reader basic parameters in the Basic

Informaon page.

Note

• The displayed parameters may vary for

dierent access control devices. There are part of

parameters listed as follows. Refer to the user manual of the device for more details.

• Some of the following parameters are not listed in the Basic Informaon page, click More to

edit the parameters.

Name

Edit the card reader name as desired.

Minimum Card Swiping Interval

If the interval between card swiping of the same card is less than the set value, the card

swiping is invalid. You can set it as 0 to 255.

Alarm of Max. Failed Aempts

Enable to report alarm when the card reading aempts reach the set value.

Max. Times of Card Failure

Set the max. failure aempts of reading card.

Card Reader Type/Card Reader Descripon

Get card reader type and descripon. They are read-only.

Default Authencaon Mode

View the default card reader authencaon mode.

Fingerprint Capacity

View the maximum number of available ngerprints.

Exisng Fingerprint Number

View the number of existed ngerprints in the device.

DS-K1T804B Series Fingerprint Access Control Terminal User Manual

HIKVISION DS-K1T804B Series User Manual

Questions and Answers: