HIMax System Appendix
HI 801 001 E Rev. 4.01 Page 115 of 122
Appendix
Application Examples
This chapter provides examples of how to mount the HIMax systems. I/O modules and
communication modules were not taken into account. They are plugged in to the remaining
slots, if required.
If required, base plates with 15 or 18 slots can also be used instead of base plates with 10
slots as presented in the examples.
Small System
This redundant system is composed of one base plate and two processor modules. The
base plate has rack ID 0.
Figure 26: Small HIMax System: One Base Plate, Two Processor Modules
Minimum System
This system without redundancy represents the absolute modicum: One base plate 0, one
processor module, one system bus module. Only one system bus A is used.
To ensure proper ventilation, a blank module must be used in slot 2. Slot 2 may not be
used for I/O modules.
Figure 27: Minimum System without Redundancy
To Next Page
Loading...
