HIMA HIMax - Default User

HIMax System 6 User Management
HI 801 001 E Rev. 4.01 Page 81 of 122
Creating user accounts is not necessary, but is a contribution to safe operation. A user
management scheme defined for a resource must contain at least one user with
administrator rights.
6.2.1 Default User
The factory user settings apply if no user accounts were set up for a resource. The factory
settings also apply after starting a processor module using the mode switch set to Init.
Factory settings
Number of users:
1
User ID: Administrator
Password: None
Access right: Administrator
i
Note that the default settings cannot be maintained if new user accounts are defined.