HIMA HIMax - Default Chapter; Table of Contents

HIMax System Table of Contents
HI 801 001 E Rev. 4.01 Page 3 of 122
Table of Contents
1 Introduction ............................................................ 7
1.1 Structure and Use of the Document..................................................................... 7
1.2 Target Audience..................................................................................................... 7
1.3 Formatting Conventions ....................................................................................... 8
1.3.1 Safety Notes ............................................................................................................ 8
1.3.2 Operating Tips ......................................................................................................... 9
2 Safety.................................................................... 10
2.1 Intended Use ........................................................................................................ 10
2.1.1 Scope..................................................................................................................... 10
2.1.2 Non-Intended Use.................................................................................................. 10
2.1.3 Operating Requirements........................................................................................ 11
2.1.4 Requirements to be met by the operator and the machine and system
manufacturers........................................................................................................
13
2.2 Residual Risk ....................................................................................................... 13
2.3 Safety Precautions............................................................................................... 14
2.4 Emergency Information....................................................................................... 14
3 Product Description .............................................. 15
3.1 Base Plates and Base Plate Types..................................................................... 16
3.1.1 Base Plate Structure.............................................................................................. 17
3.1.2 Ventilation .............................................................................................................. 18
3.1.3 Monitoring the Temperature................................................................................... 18
3.1.4 Power Supply......................................................................................................... 18
3.2 System Bus .......................................................................................................... 19
3.2.1 System Bus with Line Structure ............................................................................. 21
3.2.2 System Bus with Network Structure....................................................................... 21
3.2.3 Extending the System Bus, System bus Latency .................................................. 24
3.3 Modules and Connector Boards......................................................................... 33
3.3.1 Identifying the Module via SRS.............................................................................. 33
3.3.2 Permissible Slot Assignments................................................................................ 34
3.4 Processor module................................................................................................ 35
3.4.1 Operating System .................................................................................................. 35
3.4.2 Behavior in the Event of Faults .............................................................................. 37
3.5 Noise Blanking ..................................................................................................... 37
3.5.1 Impact of Noise Blanking ....................................................................................... 37
3.5.2 Configuring Noise Blanking.................................................................................... 38
3.5.3 Noise Blanking Sequence...................................................................................... 39
3.5.4 Considering the Effective Direction........................................................................ 41
3.6 Alarm and Sequence of Events Recording ....................................................... 42
3.6.1 Alarm and Events................................................................................................... 42
3.6.2 Creating Events ..................................................................................................... 42
3.6.3 Recording Events................................................................................................... 43
3.6.4 Transfer of Events.................................................................................................. 43