Hioki 3227 - Page 120

108
────────────────────────────────────────────────────
8.4 Command Reference
────────────────────────────────────────────────────
Synta
x
:TRANsmit:TERMinator data
dat
a
0, 1 (numerical data in NR1 format)
Functio
n
Sets the terminator followingly.
･ When data = 0, the terminator is set to "LF ＋ EOI".
･ When data = 1, the terminator is set to "CR, LF ＋ EOI".
Not
e
The initial value at the time of turning on the power supply is set to "LF＋
EOI".
Exampl
e
Transmission
:TRAN:TERM 0
The terminator is set to "LF ＋ EOI".
Synta
x
:TRANsmit:TERMinator?
Functio
n
Returns the terminator of the response messages, as 0 or 1 (data). The
settings become followingly.
･ When data = 0, the terminator is set to "LF ＋ EOI".
･ When data = 1, the terminator is set to "CR, LF ＋ EOI".
Respons
e
If headers are ON
If headers are OFF
:TRANSMIT:TERMINATOR data
data
Exampl
e
If headers are ON
If headers are OFF
Transmission
Response
:TRAN:TERM?
:TRANSMIT:TERMINATOR 1
:TRAN:TERM?
1
:TRANsmit:TERMinator
:TRANsmit:TERMinator?