.2.1 General Specifications
Measurement method and
operating method
4-terminal and dual integrator circuit
Maximum number of display digit
Resistance measurement "30000" 4 digit (3 digit when at FAST)
Temperature measurement "4000" 3 digit
Temperature conversion "±999.9" 4 digit
Sampling rate
Resistance measurement "SLOW" Approx. 4 times/second
"MEDIUM" Approx. 16 times/second
"FAST" Approx. 90 times/second
Temperature measurement Approx. 2 times/second
NOTE: When performing the comparator as reference value-per-range, in "FAST", the sampling rate
would be approximately 75 times/seconds
Response time
Resistance measurement "SLOW" Approx. 500 ms
"MEDIUM" Approx. 150 ms
"FAST" Approx. 50 ms
Auto range Contains (invalid when using the comparator)
Input over "OF" display
Comparator Set with each 15 table (selected by key operation and external
control)
Comparison method selection (HIGH/LOW, REF/%)
External control terminal mode selection (AUTO/EXT)
Buzzer mode selection (Hi/Lo, IN, OFF)
3-level (Hi, IN, Lo) fluorescent character display tube display,
external control output.
Temperature correction function Correctional temperature (0.00℃ to 40.00℃,32F to 104 F)
Standard temperature (-10.0℃ to 99.9℃,14F to 122 F)
Temperature coefficient (±9999ppm)
Optional settings are possible
Temperature conversion function Absolute temperature/temperature rise(Δt) selectable
initial resistance (0.00 mΩ to 300.00 kΩ)
initial temperature ( −10.0 ℃ to 99.9 ℃)
coefficient ( ±999.9)
Optional settings are possible
Maximum over load input 100 VDC or VAC rms (circuit protection by fuse)
To Next Page
Loading...
