Hioki 3227 - Commands Specific to the 3227

110
────────────────────────────────────────────────────
8.5 Command Summary
────────────────────────────────────────────────────
8
.5.2 Commands Specific to the 3227
Command Data format (data numbers) Explanation Pag
e
:ADJust?
Executes the zero adjustment and
queries the result
87
:COMParator
Numerical data in NR1 format (1
)
Sets the use comparator table
87
:COMParator?
Queries the use comparator table
88
:CSET
:BEEPer
OFF/HL/IN (1) Sets the buzzer mode of the
comparator
88
:BEEPer?
Queries the buzzer mode of the
comparator
88
:CMODe
HL/REF (1) Sets the comparison method of the
comparator
89
:CMODe?
Queries the comparison method of
the comparator
89
:PARAmeter
Numerical data in NRf format (2) Sets the comparison range of the
comparator
90
:PARAmeter?
Queries the comparison range of the
comparator
90
:CSET
:TABLe
Numerical data in NR1 format (1
)
Sets the setting comparator table
number
91
:TABLe?
Queries the setting comparator table
number
91
:TMODe
AUTO/EXTernal (1) Sets the external control terminal
mode of the comparator
91
:TMODe?
Queries the external control termina
l
mode of the comparator
92
:USE
ON/OFF (1) Sets whether the comparator table is
valid or invalid
92
:USE?
Queries whether the comparator
table is valid or invalid.
92
:DELTa
:MODE
DELTa/TEMPerature (1) Sets the display method of the
temperature conversion.
93
:MODE?
Queries the display method of the
temperature conversion.
93
:TABLe
Numerical data in NR1format (1) Sets the temperature conversion
table that is used.
94
:TABLe?
Queries the temperature converson
table that is used.
94