Hioki 3227 - Holding the Measurement Value

37
────────────────────────────────────────────────────
4.6 Holding the Measurement Value
────────────────────────────────────────────────────
HOLD
SAMPL
NOTE
4
.6 Holding the Measurement Value
During holding the measurement, the value which is obtained on the HOLD
key is pressed is held. The measurement and its display are not renewed
except when the external control terminal requires the measurement.
During free-running, they are renewed according to the rate which is set as
the sampling rate. See Chapter 6, "External Control Terminal", for the
measurement requirement from the external control terminal.
Pressing the
HOLD key selects either the measurement holding or the free-
running.
During holding the measurement, "HOLD" on the display lights.
An "NG" result is always detected even when not carrying out measurements.
Thus even in the HOLD state, if there is a constant current fault, "NG" on the
display lights.