Hioki 3227 - Chapter 7 The Other Functions

63
────────────────────────────────────────────────────
7.1 System Resetting
────────────────────────────────────────────────────
UP
+
TC
SET
Items Setting contents
Measurement mode Resistance measurement mode
Resistance measuring range 300 mΩ range
Sampling rate SLOW mode
Measurement holding Free-running
Comparator
Buzzer mode
Mode of the external control terminal
Comparison method of the comparator
High limit value/low limit value
All comparator tables are unused.
OFF
AUTO
HIGH/LOW
High limit value : 00000/low limit value : 00000
Temperature correction function
Standard temperature
Temperature coefficient
Unused
20.0℃
3930ppm
Temperature conversion function
Initial resistance
Initial temperature
Constant
Unused
0.00 mΩ
0.00℃
235.0
Using power supply frequency 50 Hz
GP-IB address 1
NOTE
Chapter
7
The Other Function
s
7
.1 System Resetting
1. Turn on the POWER switch on the rear panel.
2. Start the self test (self testing of the unit).
3. During the self test, press the
UP key and the TC key at the same time.
The setting contents of this unit are reset to the following initial state.
(When shipped from the factory, all items are set to the initial state.)
The temperature correction function is selected when performing the system
reset. See Section 3.2, "Turning on the Power Supply" to use the temperature
conversion function.
When the back up error is generated during the self test, this unit performs
the system reset automatically, and the setting contents are reset to the initial
state.