Hioki 3227 - Chapter 3 Unit Installation; Installing the Interfaces

19
────────────────────────────────────────────────────
3.1 Installing the Interfaces
────────────────────────────────────────────────────
WARNIN
G
To prevent electric shock, before adding or replacing the interface,
check that the power for the unit is off and the power cord and
connectors are disconnected. The fixing screws must be firmly
tightened, or the input unit may not function up to specification, or may
even fail.
To avoid the danger of electric shock, never operate the unit with an
interface removed. If you should wish to use the unit after removing an
interface, fit a blank panel over the opening of the removed unit.
NOTE
Chapter
3
Unit Installatio
n
3
.1 Installing the Interfaces
The following is the explanation for the installing method of the 9588 GP-IB
INTERFACE and the 9589 PRINTER INTERFACE.
Do not install any interface unit except the 9588 and the 9589.