Hioki 3227 - Page 123

111
────────────────────────────────────────────────────
8.5 Command Summary
────────────────────────────────────────────────────
Command Data format (data numbers) Explanation Pag
e
:DSET
:AUTO
Sets the temperature conversion
table automatically.
95
:PARAmeter
Numerical data inNR1format (3) Sets the temperature conversion
table.
95
:PARAmeter?
Queries the temperature conversion
table
96
:TABLe
Numerical data in NR1 format (1
)
Sets the setting temperature
conversion tablenumber.
96
:TABLe?
Queriesthe setting temperature
conversion table number.
97
:USE
ON/OFF (1) Sets whether the temperature
conversion table is valid or invalid.
97
:USE?
Queries whether the temperature
conversion table is valid or invalid.
97
:FREQuency
50/60 (1) Sets the use power supply frequency
.
98
:FREQuency?
Queries the use power supply
frequency.
98
:FUNCtion
RESIstance/TEMPerature (1) Sets the measurement mode.
98
:FUNCtion?
Queries the measurement mode.
99
:HEADer
ON/OFF (1) Sets the headers.
99
:HEADer?
Queries the headers.
99
:HOLD
ON/OFF (1) Sets the measurement holding.
100
:HOLD?
Queries the measurement holding
100
:MEASure
:RESIstance?
Queries the resistance measurement
value and the comparator results.
101
:TEMPerature?
Queries the temperature
measurement value and the
measurement state.
102
:RESIstance
:AUTO
ON/OFF (1) Sets the resistance auto range.
102
:AUTO?
Queries the resistance auto range.
103
:RANGe
Numerical data in NRf format (1) Sets the resistance measurement
range.
103
:RANGe?
Queries the resistance measurement
range
104
:SAMPle
FAST/MEDIUM/SLOW (1) Sets the measurement sampling rate
104
:SAMPle?
Queries the measurement sampling
rate
105