Hioki 3237 - Page 118

106
_____________________________________________________________________________________________
8.1 Preparing for Data Transfer
______________________________________________________________________________________________
NOTE
The unit is shipped from the factory with the interface set to RS-232C.
(3) 3237/38/39 Interface Setting
To use the GP-IB interface of this unit to communicate with the PC, you
must set the unit interface to GP-IB.
1
.
Press
SHIFT
.
"
SHIFT
"
lights up on the display.
2
.
Pressing
ENT
displays the menu screen.
3
.
Press to display the interface setup screen.
4
.
Pressing causes the interface currently set to flash.
"
rS
" : RS-232C
"
Prn
" : Printer
"
gPIb
" : GP-IB
5
.
Press to select
GP-IB ("
gPIb
")
.
6
.
Press
ENT
to display the address setup screen.
7
.
Press to select the GP-IB address for 3237/38/39.
8
.Press
ENT
to display the delimiter setup screen.
9
.Press to select CR-LF (CrLF) or LF (LF) as the delimiter.
10
.
Pressing
ENT
causes
"
IF
"
to flash.
11
.
Press
ENT
again to define your selection.