Hioki 3237 - Chapter 2 Installation and Preparation; Power Supply and Ground Connection

7
_____________________________________________________________________________________________
2.1 Power Supply and Ground Connection
______________________________________________________________________________________________
1
2
3
4
5
6
7
8
9
10
11
12
13
14
A
WARNING
Before turning the product on, make sure the source voltage matches
that indicated on the product's power connector. Connection to an
improper supply voltage may damage the product and present an
electrical hazard.
To avoid electrical accidents and to maintain the safety specifications
of this instrument, connect the power cord provided only to a 3-
contact (two-conductor + ground) outlet.
Chapter 2
Installation and Preparation
2.1 Power Supply and Ground Connection
1
. Confirm the power switch is OFF.
2
. Make sure the source voltage matches that indicated on the product's
power connector and connect the power cord supplied to AC inlet on the
rear panel.
3
. Plug in the power cord. Insert the plug directly into the outlet.