i
_____________________________________________________________________________________________
______________________________________________________________________________________________
NOTE
Before using the product, make sure that the insulation on the probes is undamaged
and that no bare conductors are improperly exposed. Using the product in such
conditions could cause an electric shock, so contact your dealer or Hioki
re
resentative for re
air.
Introduction
Inspection
Thank you for purchasing the HIOKI "3237, 3238, 3239 DIGITAL
HiTESTER."
To obtain maximum performance from the product, please read this manual
first, and keep it handy for future reference.
When you receive the product, inspect it carefully to ensure that no damage
occurred during shipping. In particular, check the accessories, panel
switches, and connectors. If damage is evident, or if it fails to operate
according to the specifications, contact your dealer or Hioki representative.
Accessories
L9170-10 TEST LEAD 1
Instruction Manual 1
Power cord 1
Spare fuse 0.5 A (for 100 V, 120 V), 0.25 A (for 220 V, 240 V)
2 A (for the 3238/39) 1
Before using the product the first time, verify that it operates normally to
ensure that the no damage occurred during storage or shipping. If you find
any damage, contact your dealer or Hioki representative.
Inspection before use
When measuring a dangerous voltage or current, or when a measurement of
high reliability is required, always carry out the following confirmation
before using.
No damage to the power cord, test lead and the produt itself
No inaccurate measurement values are shown when connected to a
measurement target with clear values (non-defective sample, calibrator,
etc.) and under the setting for the test conditions used by the customer
To Next Page
Loading...
