Hioki 3237 - Page 86

74
_____________________________________________________________________________________________
7.4 Command Reference
______________________________________________________________________________________________
Syntax
∗TST?
Function
Causes the 3237/38/39 to perform the self test, and returns the result there of as a numerical data
value in NR1 format (0 to 7).
The results are shown below. When each bit is set to "1," an associated error has occurred.
Response
syntax
Headers: ON ∗TST data
Headers: OFF data
Example
Headers: OFF
Transmission ∗TST?
Response 2
RAM error
bit7 bit6 bit5 bit4 bit3 bit2 bit1 bit0
Not used Not used Not used Not used Not used Not used
RAM ROM
Syntax
∗WAI
Function
The next command executes after the command now executing.
Note
Executing the ∗WAI command has no effect, since the 3237/38/39 specific commands all involve
sequential-type commands.
The ∗WAI command is accepted, since it is a common command for the
IEEE488.2 1987 standard.
∗TST? command
Requests execution of, and queries the result of, the self test.
∗WAI command
Waits until previous event is completed.