9.6 Cleaning
索引
4
3
2
1
7
6
5
10
9
8
Maintenance and Service
To clean the instrument, wipe it gently with a soft cloth moist-
ened with water or mild detergent. Never use solvents such as
benzene, alcohol, acetone, ether, ketones, thinners or gasoline,
as they can deform and discolor the case.
5.
Fasten a new pin. Press the tip of the pin against a hard
board so that the pin won’t spring out, and push the con-
nector onto the pin.
6.
Assemble the pin type lead in the reverse order of disas-
sembling.
Do not pull or twist the cable.
7.
To avoid broken wires and contact failures, after tighten-
ing the cable lock, gently tug and twist the cable to check
it is firmly held.
8.
Check the performance. Measure an object with a known
resistance. Make sure that the measured resistance is
correct before using the pin type lead.
Model 9465-90 tip pin
9.6 Cleaning
To Next Page
Loading...
