6.4 Auto-power-save Feature (APS)
The auto-power-save feature can be used to control the instru-
ment's power consumption. When any of the following condi-
tions has continued for approximately ten seconds with no keys
pressed, power to the instrument will be turned off automatically.
• When the resistance value displayed is "- - - -"
• Hold (measurement stopped)
• Conditions other than measurement conditions (each configu-
ration screen, data reading screen)
• Conditions following completion of communication
"APS" will begin to flash one minute before the power turns off.
6.4 Auto-power-save Feature (APS)
• This feature is turned on under initial configura-
tion conditions. When the auto-power-save fea-
ture is unnecessary, such as when using the
instrument continuously, turn this feature off.
• When the auto-power-save screen has been dis-
played unintentionally, turn the power on again.
The instrument's settings will be restored
unchanged.
To Next Page
Loading...
