6.2 Auto-hold Feature
This feature can be used to recognize automatically the stability
of measured values and to hold measured values.
Configuring the Auto-hold Feature
Press several times key to display the icon.
Releasing the Hold
Release the hold by pressing key or the PRESS button on
the 9466 REMOTE CONTROL SWITCH.
Releasing the Auto-hold Feature
Press several times key to turn off the icon.
6.2 Auto-hold Feature
Auto-hold
Auto-
memory
Auto-hold &
Auto-memory
OFF
• When "- - - -" is displayed, the auto-hold feature
cannot be used.
• The auto-hold function can be used when "OF" is
displayed on-screen.
• When using the auto-memory feature together
with this feature, measured values can be saved
automatically after holding them.
In order to judge whether the "OF" display has
resulted from mistaken range settings, using the
comparator as well, or setting the comparator
buzzer to "WARN/FAIL," is recommended.
"Section 4.4 Setting the Comparator Buzzer" (⇒
p.61)
To Next Page
Loading...
