1.5 Measurement Flowchart
索引
4
3
2
1
7
6
5
10
9
8
Overview
Zero-adjustment
(
⇒ p.37)
Implement the zero-adjust feature
in accordance with the zero-
adjust method for the test lead
used.
Starting Measurement
1. Connect the test lead to the
subject of measurement.
2. Read the measurement val-
ues.
3. Hold the measurement values.
4. Store the measurement val-
ues.
Ending Measurement
1. Disconnect the test lead and
turn off the power.
2. If you want to load the stored
measurement data to a per-
sonal computer, connect the
instrument to the computer
using the USB cable and
transfer the data. (This
requires installation of data-
transfer software.)
(⇒ p.81)
When using the 9465-10
Measurement
data
To Next Page
Loading...
