Hioki BT3564 - Page 123

8.5 Message List
117
8
Chapter 8 RS-232C/GP-IB Interfaces
:SYSTem:EOM:PULSe
<HOLD/PULSe> Selects the EOM pulse width
143
:SYSTem:EOM:PULSe?
(0.001 to 0.099) Queries the EOM pulse width setting
143
Terminator
:SYSTem:TERMinator
0/ 1 Sets the terminator 142
:SYSTem:TERMinator?
0/ 1 Queries the terminator 142
System Reset
:SYSTem:RESet
Executes a system reset, including
saved measurement setting state data
143
EXT I/O
:IO:OUT
0 to 1023 EXT I/O output 144
:IO:IN?
0 to 31 EXT I/O input 144
Trigger
:INITiate:CONTinuous
1/ 0/ ON/OFF Sets continuous measurement 147
:INITiate:CONTinuous?
ON/ OFF Queries the continuous measurement
setting
147
:INITiate[:IMMediate]
Trigger wait setting 147
Trigger Source Setting
:TRIGger:SOURce
IMMediate/ EXTernal Sets the trigger source 148
:TRIGger:SOURce?
IMMEDIATE/ EXTERNAL Queries the trigger source setting 148
:TRIGger:DELay:STATe
1/ 0/ ON/OFF Sets the trigger delay 148
:TRIGger:DELay:STATe?
ON/ OFF Queries the trigger delay setting 148
:TRIGger:DELay
<Delay time> Sets trigger delay time 149
:TRIGger:DELay?
0 to 9.999 Queries the trigger delay time 149
Reading Measured Values
:FETCh?
<Measured resistance
value>, <Measured
voltage value>
V mode
<Measured resistance
value>  mode
<Measured voltage val-
ue> V mode
Reads the most recent measurement 149
:READ?
<Measured resistance
value>, <Measured
voltage value>
V mode
<Measured resistance
value>  mode
<Measured voltage val-
ue> V mode
Executes a measurement and read
the measured values
150
Message ([ ] = optional) Data Formats (Re-
sponse data if a Query)
Description Ref
page
HIOKI BT3564A961-02