Hioki BT3564 - Page 122

8.5 Message List
116
:SYSTem:CALibration:AUTO?
ON/ OFF Queries the automatic self-calibration
setting
139
Trigger Input Measured Value Ouput
:SYSTem:DATAout
1/ 0/ ON/OFF Sets measurement value output upon
triggering
139
:SYSTem:DATAout?
ON/ OFF Queries measurement value output
upon triggering
139
Key Beeper
:SYSTem:BEEPer:STATe
1/ 0/ ON/OFF Sets the key beeper 140
:SYSTem:BEEPer:STATe?
ON/ OFF Queries the key beeper setting 140
Line Frequency
:SYSTem:LFRequency
AUTO/50/ 60 Selects the AC line frequency 140
:SYSTem:LFRequency?
AUTO/50/ 60 Queries the AC line frequency selection 140
Key-Lock
:SYSTem:KLOCk
1/ 0/ ON/OFF Sets the key-lock 140
:SYSTem:KLOCk?
ON/ OFF Queries the key-lock setting 140
EXT I/O Output
:SYSTem:ELOCk
1/ 0/ ON/OFF Sets the external input terminal lock 141
:SYSTem:ELOCk?
ON/ OFF Queries the external input terminal
lock on/off setting
141
Local
:SYSTem:LOCal
Sets local control 141
Saving and Loading Measurement Setting States
:SYSTem:SAVE
<Table No.> Saves the measurement setting state 141
:SYSTem:LOAD
<Table No.> Loads a measurement setting state 141
:SYSTem:BACKup
Backups current measurement config-
uration
141
Header Present
:SYSTem:HEADer
1/ 0/ ON/OFF Sets header present 142
:SYSTem:HEADer?
ON/ OFF Queries the header present setting 142
ERR Output
:SYSTem:ERRor
SYNChronous/
ASYNchronous
Sets error output timing 142
:SYSTem:ERRor?
SYNCHRONOUS/
ASYNCHRONOUS
Queries the error output timing setting 142
EOM Output
:SYSTem:EOM:MODE
<HOLD/PULSe> Selects the EOM output mode
143
:SYSTem:EOM:MODE?
(<HOLD/PULSE>) Queries the EOM output mode setting
143
Message ([ ] = optional) Data Formats (Re-
sponse data if a Query)
Description Ref
page
HIOKI BT3564A961-02