5
BEFORE OPERATION
4.2 FACTORY-SUPPLIED INDOOR UNIT
COMPONENTS
Accessory Image Qty. Remarks
Gasket 12
12 gaskets for each
connections between the
valves (inlet/outlet) .
(6 of G1" and 6 of G3/4")
1
Connect at the water inlet
of indoor unit, used to shut
impurities in water.
Cable tie 3 Used for wiring binding.
Drain pipe
clamp
1
Used for fastening drain
hose and drain pipe.
Drain pipe 1
Used for drain hose of
pressure relief valve
connection
Instruction
manual
1
Basic instructions for the
installation of the device.
Energy
1
Pressure relief
valve
1
Used for pressure relief for
DHW
The previous accessories are supplied inside the packing
assembly (on the top of the indoor unit).
outdoor unit needs to be available.
If some of these accessories are not packed with the unit or
any damage to the unit is detected, please contact your dealer.
3 Remove the 4 L-shaped feet at 4 corners,and then remove
the indoor unit from wooden pallets, and place it carefully on
shaped feet
the factory-supplied accessories located on the top of the unit.
Two people are required when handling because of the weight
of the unit.
To Next Page
Loading...
