EasyManuals Logo

HOLDEN WM II 2012 Series User Manual

HOLDEN WM II 2012 Series
340 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #267 background imageLoading...
Page #267 background image
Black plate (21,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
/
12
Vehicle Care 10-21
On Caprice V-Series models it is
strongly recommended that the high
and low beam bulbs are replaced by
a Holden Dealer, as they operate at
high voltage.
Headlights
Outboard low beam
1. To access the headlights, see
Front lights under Bulb
Replacement on page 1018 and
follow the steps.
o
p
e
n
c
l
o
s
e
e
n
c
l
o
2. Rotate the outboard dust cap
anticlockwise and remove.
3. Grasp the wiring connector/bulb
assembly and twist
anticlockwise one eighth of a
turn to remove.
4. Separate the bulb from the
wiring connector.
5. Install the new bulb into the
wiring connector.
Note: Ensurethebulbisclean
before fitting.
6. Twist the wiring connector/bulb
assembly clockwise one eighth
ofaturntoinstall.
7. Install the dust cap, ensuring the
rubber seal is in place.
8. Install components removed in
Step 1.
9. Check light operation.
Inboard high beam
1. To access the headlights, see
Front lights under Bulb
Replacement on page 1018 and
follow the steps.
o
p
e
n
c
l
o
s
e
e
n
c
l
o
2. Rotate the inboard dust cap
anticlockwise and remove.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HOLDEN WM II 2012 Series and is the answer not in the manual?

HOLDEN WM II 2012 Series Specifications

General IconGeneral
BrandHOLDEN
ModelWM II 2012 Series
CategoryAutomobile
LanguageEnglish

Related product manuals