Black plate (65,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
Vehicle Care 10-65
6. Attach one end of the RED
jumper lead to the jump start
positive post (A).
7. Attach the other end of the RED
jumper lead to the positive
terminal (B) of the charged
battery.
8. Attach one end of the BLACK
jumper lead to the negative
terminal (C) of the charged
battery.
9. Attach the other end of the
BLACK jumper lead to the jump
start negative post (D).
10. Start the engine in the vehicle
with the charged battery and
allow to idle for at least
4 minutes.
11. Start the engine of the vehicle
with the flat battery.
12. Turn off the headlights, rear
demister, air conditioning and
audio system of the vehicle
with the flat battery.
13. Allow both vehicles to run for at
least 4 minutes while
connected, to stabilise battery
voltage.
14. Leave the engines running
while removing the BLACK
negative jumper lead first,
followed by the RED positive
jumper lead.
Note:
.
After removing the jump leads,
refit the red protective cap to the
positive jump start post.
.
While removing each clamp, do
not touch any other metal while
the other end remains attached.
Towing
Towing the Vehicle
{
WARNING
Flat tray towing is the only
recommended towing procedure.
A slot and rope location is
provided to move a bogged or
disabled vehicle a short distance
or to pull the vehicle onto a flat
tray tow truck.
Use only wheel lashings to
secure the vehicle to the flat tray
tow truck.
Do not attach towing equipment
to the bumpers or brackets,
suspension or cross members.
To prevent damage, use only
proper towing equipment.
To Next Page
Loading...
Need help?
General
