Black plate (51,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
Vehicle Care 10-51
After a temporary puncture repair,
replace t he tyre sealant canister.
To remove the canister:
1. Unlock the air-only delivery
hose (D) from the t yre sealant
canister by pulling up on the
lever (H).
2. Pull the air-only delivery
hose (D) from the t yre sealant
canister.
3. Unwrap the sealant-air delivery
hose (C) from the air
compressor (G).
4. Rotate the tyre sealant
canister (B) anticlockwise so the
sealant-air delivery hose (C) i s
aligned with the slot i n the
compressor.
5. Lift the tyre sealant canister (B)
from the compressor and
replace w ith a new tyre sealant
canister, available from a Holden
Dealer.
6. Dispose of the tyre sealant
canister at a Holden Dealer or in
accordance with local or state
codes and practices.
To install a new tyre sealant
canister:
1. Align the sealant-air delivery
hose (C) with the slot in the
compressor.
2. Push the tyre sealant
canister (B) down and rotate it
clockwise.
3. Wrap the sealant-air delivery
hose (C) around the compressor
channel.
4. Push the air-only delivery
hose (D) onto the tyre sealant
canister (B) inlet.
5. Push the lever (H) down.
Tyre Changing
{
WARNING
All passengers must be out of the
vehicle while it is being jacked.
Do not jack a vehicle with a trailer
attached. Remove the trailer first.
Only jack the vehicle on a hard,
level s urface.
Ensure moving parts of the jack
are adequately lubricated
before use.
Only use the jack at the
designated lifting points. Use in
other locations may result in t he
vehicle falling off the jack or
cause damage to the vehicle.
If using a jack (or hoist) other
than the jack supplied with the
vehicle, see “Trolleyjackor
vehicle hoist” under Tyre
Changing on page 10‑51.
(Continued)
To Next Page
Loading...
Need help?
General
