Black plate (50,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
10-50 Vehicle Care
{
WARNING
Do not run the engine i n an
enclosed area or with passengers
in the vehicle. See Fuel on
page 9‑23 for exhaust gas
warnings.
6. Switch the on/off switch (A) to
the I positi on.
{
WARNING
Do not over-inflate tyres due to
risk of injury or damage to the
tyre. Refer to the tyre placard for
recommended inflation pressure.
7. Check the pressure gauge (E).
If there is no pressure reading
while the compressor is running,
check for leaks at the connection
between the hose and the tyre
valve.
8. Inflate the tyre to the
recommended inflation pressure
using the air pressure gauge (E).
The pressure gauge (E) reads
slightly high while the
compressor is on.
9. Switch the compressor off to get
an accurate reading.
The compressor may be
switched on and off until the
correct pressure is reached.
10. Switch the on/off switch (A) to
the O position.
{
WARNING
Be careful when handling the tyre
sealant and air compressor kit as
they may be hot after usage.
11. Disconnect the 12 volt power
connection (F) and the air-only
delivery hose (D).
12. Replace the tyre valve cap.
13. Place the tyre sealant and air
compressor kit back in
the boot.
{
WARNING
Always stow the tyre sealant and
air compressor kit in its original
position. Unsecured loads
increase the risk of injury on
heavy braking, sudden avoidance
manoeuvres or collision.
Replacing the tyre sealant canister
B
C
To Next Page
Loading...
Need help?
General
