Black plate (49,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
Vehicle Care 10-49
21. Stop at a safe location to check
the tyre pressure. To inflate
tyres without sealant, see
“Inflating tyres without sealant”
later in this section.
22. If the tyre pressure has fallen
more than 10 psi (68 kPa)
below the recommended
inflation pressure, do not
continue driving. Contact a
Holden Dealer.
If the tyre pressure has
dropped l ess than 10 psi
(68 kPa), inflate to the
recommended inflation
pressure.
23. Wipe off any sealant from the
wheel, tyre or vehicle.
24. Dispose of the used tyre
sealant canister at a Holden
Dealer or in accordance with
local and state codes and
practices. Replace with a new
canister.
This is a temporary puncture repair.
Take the vehicle to a Holden Dealer
to have the tyre repaired or replaced
as soon as possible.
Inflating tyres without sealant
A
E
H
F
G
D
A. On/off switch
D. Air-only delivery hose
E. Pressure gauge
F. 12 volt power connection
G. Air compressor
H. Lever
1. Lift the lever (H) and pull the
air-only delivery hose (D) from
the bottom of the kit.
2. Remove the t yre valve cap by
rotating it anticlockwise.
3. Push the air-only delivery
hose (D) onto the tyre valve and
push the lever (H) down to
secure.
4. Plug the 12 volt power
connection (F) into the vehicle’s
power socket. See Power
Outlets on page 5‑6.
Do not jam the 12 volt power
connection cable in the door,
boot or window.
5. Start the engine and let i t i dle to
ensure the battery does not
run down.
To Next Page
Loading...
Need help?
General
