Black plate (48,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
10-48 Vehicle Care
{
WARNING
If the recommended pressure
cannot be reached after
approximately 15 minutes, the
vehicle should not be driven. The
tyre is too severely damaged and
the tyre sealant and air
compressor kit cannot inflate the
tyre. Disconnect and stow the tyre
sealant and air compressor kit
back in its original position.
Contact a Holden Dealer.
{
WARNING
Be careful when handling the tyre
sealant and air compressor kit as
they may be hot after usage.
15. Unplug the 12 volt power
connection (F) from the power
socket.
16. Rotate the sealant-air delivery
hose (C) anticlockwise and
remove.
17. Replace the tyre valve cap.
18. Place the tyre sealant and air
compressor kit back in the
boot area.
{
WARNING
Always stow the tyre sealant and
air compressor kit in its original
position. Unsecured loads
increase the risk of injury on
heavy braking, sudden avoidance
manoeuvres or collision.
19. After inflating the tyre, remove
the maximum speed label and
place it in a visible location on
the instrument panel.
It reminds you to drive
cautiously and not to exceed
90 km/h until the damaged tyre
is replaced or repaired.
20. Drive the vehicle immediately
for at least 8 km to distribute
the sealant evenly within
the tyre.
To Next Page
Loading...
Need help?
General
