Black plate (23,1)
Holden WM Caprice Owner Manual (MY12.5) - 2012 - CRC 1st Edition - 6/28
12
Vehicle Care 10-23
3. Rotate the bulb holder
anticlockwise and remove.
4. Lightly press the bulb and twist
anticlockwise out of the holder.
5. Insert the new bulb and install
the bulb holder following the
guide tab. Ensure that the same
colour bulb is used.
6. Install components removed in
Steps 1 and 2.
7. Check light operation.
Tail lights
Tail light assembly
A
C
B
B
A
Driver side shown
A. Turn signal light (PY21W
amber bulb)
B. Reverse light (P21W bulb)
C. Rear light wiring connector
Note: The stop/tail light bulb is an
LED and is only replaceable by a
Holden Dealer.
To Next Page
Loading...
Need help?
General
