Honeywell 301C User Manual

510324 301C User Manual 13
4/07 Honeywell
Introduction
Introduction
The 301C controllers act as nerve centres for gas detection networks,
providing continuous monitoring for up to 96 connected units (plus 1
301ADI). Since the controllers are factory programmed to your
specifications, installation is limited simply to mounting and connecting
them. Once installed and connected, the controllers allow you to
monitor, adjust or reconfigure an entire network of units.
The 301C has a supplementary option of the wireless coordinator that
enables this controller to communicate with and manage (up to 60)
wireless gas detection devices in addition to its regular capabilities.
Intended Use
The controller is intended to monitor an entire gas detection network
around the clock. The unit offers logging capabilities, creating log files
of all transmitter concentrations and alarms for analysis. The unit is
also equipped with grouping or zoning capabilities that allow users to
query and monitor specific groups of transmitters or specific transmitter
zones.
Receiving and Unpacking
When you receive your package:
• Check that the package is undamaged
• Carefully open the package.
• Locate the packing slip, or purchase order, and verify that all items
on the order are present and undamaged
Note: If the package or any of its contents are damaged, please refer to
the Warranty section at the back of the manual for instructions.

Honeywell 301C Specifications

General

Controller Type	Temperature Controller
Control Mode	ON/OFF, PID
Input Voltage	100-240 VAC
Input	Thermocouple, RTD
Output	Relay, SSR
Operating Temperature	0 to 50°C
Contact Rating	5A @ 250 VAC (Relay)