Honeywell 301C User Manual

52 301C User Manual 510324
Honeywell 4/07
System Programming
Event Menu
Status
This screens displays the current event status and allows you to either
enable or disable, depending on the current status.
Enable event:This is a “toggle” switch; press Enter to change the value
from Enable to Disable and vice versa
If you have just gone through all the steps and programmed an event,
this screen will display “Enable event”. Press Enter to activate all the
parameters and enable the Event.
If you are consulting an existing Event, this screen would display
“Disable event”. You can press Enter to disable an Event that you do
not wish to delete but do not want functioning for any time. The
programming of this Event is always present, which means that you can
easily reactivate it by scrolling to this screen and pressing Enter.
Database
This screens displays the options linked to the database:
Erase current event:Lets user erase the current event
Erase all events:Lets user erase all events
3. EVENT 001
-Status : disabled-
Enable event
.
3. Events 001
-Database-
Erase current event
Erase all events

Honeywell 301C Specifications

General

Controller Type	Temperature Controller
Control Mode	ON/OFF, PID
Input Voltage	100-240 VAC
Input	Thermocouple, RTD
Output	Relay, SSR
Operating Temperature	0 to 50°C
Contact Rating	5A @ 250 VAC (Relay)