Honeywell 301C User Manual

36 301C User Manual 510324
Honeywell 4/07
System Programming
Tx Info Menu
Alarm A, B and C Menus
Since the display screens are identical for each of the Alarms, they
have been combined into one section for the purpose of this manual.
However, each Alarm must be configured separately according to your
specifications.
This option allows you to set minimum and maximum alarm levels for
alarms A, B and C. What this does is set a tolerance range within
which no actions are taken. However, if gas concentrations should go
over the set maximum level, an alarm will be triggered. The alarm will
not be shut off and reset until gas concentrations fall below the
minimum level defined.
• Use the keypad arrows to move the cursor arrow to either MIN or
MAX
• Press Enter to select the field for modification
• Use the keypad up or down arrows to increase or decrease the
value
• Press Enter to validate the value.
1. Tx Info 001
-Alarm A-
MIN MAX
0.00% 0.00%
1. Tx Info 001
-Alarm A-
MIN MAX
0.00% 0.00%

Honeywell 301C Specifications

General

Controller Type	Temperature Controller
Control Mode	ON/OFF, PID
Input Voltage	100-240 VAC
Input	Thermocouple, RTD
Output	Relay, SSR
Operating Temperature	0 to 50°C
Contact Rating	5A @ 250 VAC (Relay)