Honeywell 301C User Manual

510324 301C User Manual 29
4/07 Honeywell
System Programming
Tx Info Menu
Ident Menu
The Ident, or identification menu allows you to consult a component’s
network ID:
The upper right corner of the screen shows the component’s address. If
you know the address of the device whose information you wish to
consult:
• Use the arrows to move the cursor arrow to the on-screen address
• Press Enter (you can edit the value when the number is flashing)
• Use the up or down arrows to increase or decrease the value
• Press Enter again to validate the entry and display the information
for the desired device.
The bottom left corner of the display shows the transmitter name (ex.:
301D2 - product name) and the sensor type (ex.: CH4 - methane
sensor). These values can also be changed for Group or Vulbus
product types. The procedure is identical for both fields:
Programming or changing a product or sensor type
• Use the arrows to move the cursor to the product type field.
• Press Enter to select the field (the value can be modified when
flashing)
• Use the arrows to scroll through the list of product types and press
Enter when the desired product or sensor appears
1. Tx Info 001
-Ident-
NotVul
CO2 (IR)

Honeywell 301C Specifications

General

Controller Type	Temperature Controller
Control Mode	ON/OFF, PID
Input Voltage	100-240 VAC
Input	Thermocouple, RTD
Output	Relay, SSR
Operating Temperature	0 to 50°C
Contact Rating	5A @ 250 VAC (Relay)