Honeywell 301C User Manual

28 301C User Manual 510324
Honeywell 4/07
System Programming
Tx Info Menu
Other devices will have the following Tx INFO menu options:
Ident: Allows you to consult the
network component’s
identification information.
Scale(1): Allows you to view or
change the detection
range
Scale(2): Allows you to view or
change the range factor
and unit of measurement
Display: Allows you to consult or
change the label (or
name) given to a specific
component
Alarm
A, B, C: Allows you to program
various alarm levels
Operating Displays lifetime counter
Times: and time (in hours) since
the last calibration
Status Code: Displays Tx or Node
status and sensor status
(in hexadecimal value)
Erase Erases all the
Current Tx: configuration for the
selected device entry
Change Tx: Not available for
Address addresses 97-170
1. Tx Info 121
-Scale(2)-
Factor 00001
Units ppm
1. Tx Info 121
-Scale(1)-
Max 00250
Min 00000
1. Tx Info 121
-Operating Times-
Lifetime: 00000
Since Calib: 00730
1. Tx Info 121
-Ident-
301W
CO2 (IR)
1. Tx Info 121
-Alarm A-
MIN MAX
0.00% 0.00%
1. Tx Info 121
-Display-
edit (20 char.max)
301W NO2 Ad121
1. Tx Info 121
-Alarm C-
MIN MAX
0.00% 0.00%
1. Tx Info 121
-Alarm B-
MIN MAX
0.00% 0.00%
1. Tx Info 121
erase current Tx
Change Tx Address
1. Tx Info 121
-Status Code-
Tx Status: 12FAh
Snsr status: 4407h

Honeywell 301C Specifications

General

Controller Type	Temperature Controller
Control Mode	ON/OFF, PID
Input Voltage	100-240 VAC
Input	Thermocouple, RTD
Output	Relay, SSR
Operating Temperature	0 to 50°C
Contact Rating	5A @ 250 VAC (Relay)