Honeywell 301C User Manual

510324 301C User Manual 39
4/07 Honeywell
System Programming
Tx Info Menu
Change Tx Address
Selecting Change Tx Address allows users to move a device from one
TX address to another:
• Use the arrows to scroll to Change Tx Address and press Enter to
select
• In the next screen, scroll to the address number and press Enter to
select
• Use the up or down arrows to increase or decrease the address
value and press Enter to validate the new address.
The Change Tx address option is only available (active) for device
address 1 to 96 and if there is a Modbus device connected.
If the address is valid, the screen will display “Processing”.
If the address is invalid, the screen will display “Invalid Tx” and return to
the Change Tx Address screen (you cannot change the address for
GasPoint devices)
A final screen will display either “Error” or “Success” (re-start procedure
if Error is displayed).
Note: If a device address is changed to an one already associated to
another device, the existing data will be overwritten. Customers
should know their network’s address assignments and be careful
when changing a Tx address.
Remember to delete the original Tx address to avoid duplicate
entries.
1. Tx Info 001
erase current Tx
Change Tx Address
1. Tx Info 001
To address: 001
1. Tx Info 001
Processing...

Honeywell 301C Specifications

General

Controller Type	Temperature Controller
Control Mode	ON/OFF, PID
Input Voltage	100-240 VAC
Input	Thermocouple, RTD
Output	Relay, SSR
Operating Temperature	0 to 50°C
Contact Rating	5A @ 250 VAC (Relay)