Honeywell Apex - Page 72

72
MAN0604_Issue 09_02-2013 Apex
2110M8030
4. OPERATION
Calibration Info Display Menu
This option displays a screen that reports information about the calibration of the Transmitter Unit
andCertiedSensor.Anexampleofatypicalscreenisasfollows:
Calibration Info
Last Calib
:1
63
Next Calib
:4
205
Gas: PH3
FSD: 1.200 ppm
Calib Interval
:4
368
PredictedLife: 8571
Last Calib Displays the time in hours since the last calibration was carried out.
Next Calib Displays the time in hours to the next calibration based on the
calibration interval (Calib Interval).
Gas  DisplaysthetypeofgascartridgettedtotheCertiedSensor.
FSD Displays the maximum range of measurement.
Calib Interval Displays the calibration interval in hours.
Predicted Life Displays the typical life of the cartridge in hours.
CurrentCong Display Menu
This option displays 2 screenssequentiallythatreportthecurrentTransmitterUnitandCertied
Sensorcongurationsettings,e.g.alarmsettings,relaycongurations,etc.
Initial Screen
Anexampleofatypicalinitialscreenisasfollows:
Current Config
Gas: PH3
FSD: 1.200 ppm
Alarm1
:0
.150 ppm
Alarm2
:0
.300 ppm
Inhibit: 1.2mA
Warning: 3.0mA
Overrange 21.0mA
Gas  ReportsthetypeofgascartridgettedtotheCertiedSensor.
FSD Displays the maximum range of gas measurement.
Alarm1 Reports the alarm value set for Alarm1.
Alarm2 Displays the alarm value set for Alarm2.
Inhibit Reportsthevalueatwhichthe4-20mAInhibitalarmissettoactivate.
Warning Displaysthevalueatwhichthe4-20mAWarningalarmissetto
activate.
Overrange Reportsthevalueatwhichthe4-20mAOverrangealarmisset
to activate.