horsch LEEB LT - Page 95

d
e
f
a
b
c
h
g
l
m
n
o
P
r
i
k
s
(n) area to be cultivated in hectare
¾ Select the button and enter the area in the input 󰘰eld (n).
¾ Enter the desired placing quantity in litres per hectare in the input 󰘰eld (o).
¾ Use the buttons to navigate up and down. If the line into which the value shall be entered is
framed in red, select it with the ENTER button. The desired value can be entered using the
left and right buttons. Now con󰘰rm the value with the ENTER button.
¾ Calculating the 󰘰lling quantity (k) by using the currently set placing quantity (o) in litres per hectare
of the area to be cultivated (n).
¾ The required 󰘰lling quantity is displayed in the input 󰘰eld (k).
¾ Start 󰘰lling (a).
¾ Filling ends when the 󰘰lling quantity is reached, and the pump is deactivated.
NOTE
¾ If the value of lling limit 2 is greater than the rated volume of the spraying mixture container, a
message is displayed at the terminal and the 󰘰lling limit is reduced to the rated volume.
¾ Filling stops at lling limit 1 (if a value is entered). Starting 󰘰lling again 󰘰lls the spraying mixture
container up to lling limit 2.
¾ When lling limit 1 is reached, the system automatically switches over to lling limit 2 if its value is
greater than the current 󰘰lling limit or the current 󰘰lling level of the spraying mixture container.
Starting 󰘰lling again 󰘰lls the spraying mixture container up to lling limit 2.
¾ If no value is entered at lling limit 1, 󰘰lling runs up to the value of lling limit 2 and 󰘰lling 󰘰nishes.
¾ If the value of lling limit 1 is greater than the value of lling limit 2, 󰘰lling runs up to the value of lling
limit 2 and 󰘰lling 󰘰nishes.
92 93