HP 5120 EI Series

182
Figure 62 Network diagram
Configuration procedure
IMPORTANT:
Make sure that you have configured the devices in the service provider network to allow QinQ packets to
pass through.
1. Configure PE 1:
{ Configure GigabitEthernet 1/0/1:
# Configure GigabitEthernet 1/0/1 as a trunk port and assign it to VLAN 100 and VLANs 10
through 70..
<PE1> system-view
[PE1] interface gigabitethernet 1/0/1
[PE1-GigabitEthernet1/0/1] port link-type trunk
[PE1-GigabitEthernet1/0/1] port trunk permit vlan 100 10 to 70
# Configure VLAN 100 as the PVID for the port.
[PE1-GigabitEthernet1/0/1] port trunk pvid vlan 100
# Enable basic QinQ on the port.
[PE1-GigabitEthernet1/0/1] qinq enable
[PE1-GigabitEthernet1/0/1] quit
{ Configure GigabitEthernet 1/0/2:
# Configure GigabitEthernet 1/0/2 as a trunk port and assign it to VLAN 100 and VLAN 200.
[PE1] interface gigabitethernet 1/0/2
[PE1-GigabitEthernet1/0/2] port link-type trunk
[PE1-GigabitEthernet1/0/2] port trunk permit vlan 100 200
[PE1-GigabitEthernet1/0/2] quit
# Set the TPID value in the outer VLAN tag to 0x8200 on the port.
[PE1] qinq ethernet-type 8200