HP 5120 EI Series

183
{ Configure GigabitEthernet 1/0/3:
# Configure GigabitEthernet 1/0/3 as a trunk port and assign it to VLAN 200 and VLANs 30
through 90.
[PE1] interface gigabitethernet 1/0/3
[PE1-GigabitEthernet1/0/3] port link-type trunk
[PE1-GigabitEthernet1/0/3] port trunk permit vlan 200 30 to 90
# Configure VLAN 200 as the PVID for the port.
[PE1-GigabitEthernet1/0/3] port trunk pvid vlan 200
# Enable basic QinQ on the port.
[PE1-GigabitEthernet1/0/3] qinq enable
[PE1-GigabitEthernet1/0/3] quit
2. Configure PE 2:
{ Configure GigabitEthernet 1/0/1:
# Configure GigabitEthernet 1/0/1 as a trunk port and assign it to VLAN 200 and VLANs 30
through 90.
<PE2> system-view
[PE2] interface gigabitethernet 1/0/1
[PE2-GigabitEthernet1/0/1] port link-type trunk
[PE2-GigabitEthernet1/0/1] port trunk permit vlan 200 30 to 90
# Configure VLAN 200 as the PVID for the port.
[PE2-GigabitEthernet1/0/1] port trunk pvid vlan 200
# Enable basic QinQ on the port.
[PE2-GigabitEthernet1/0/1] qinq enable
[PE2-GigabitEthernet1/0/1] quit
{ Configure GigabitEthernet 1/0/2:
# Configure GigabitEthernet 1/0/2 as a trunk port and assign it to VLAN 100 and VLAN 200.
[PE2] interface gigabitethernet 1/0/2
[PE2-GigabitEthernet1/0/2] port link-type trunk
[PE2-GigabitEthernet1/0/2] port trunk permit vlan 100 200
[PE2-GigabitEthernet1/0/2] quit
# Set the TPID value in the outer VLAN tag to 0x8200 on the port.
[PE2] qinq ethernet-type 8200
{ Configure GigabitEthernet 1/0/3:
# Configure GigabitEthernet 1/0/3 as a trunk port and assign it to VLAN 100 and VLANs 10
through 70.
[PE2] interface gigabitethernet 1/0/3
[PE2-GigabitEthernet1/0/3] port link-type trunk
[PE2-GigabitEthernet1/0/3] port trunk permit vlan 100 10 to 70
# Configure VLAN 100 as the PVID for the port.
[PE2-GigabitEthernet1/0/3] port trunk pvid vlan 100
# Enable basic QinQ on the port.
[PE2-GigabitEthernet1/0/3] qinq enable
[PE2-GigabitEthernet1/0/3] quit