Hardware options installation 125
Installing a hot-plug AC power input module
1. Access the product rear panel.
2. Remove the power supply blank.
3. Slide the power input module into the bay until it clicks into place.
4. Connect the power cord to the power supply.
5. To prevent accidental power cord disconnection when sliding the server in and out of the rack,
secure the power cord in the strain relief strap attached to the power input module handle:
a. Unwrap the strain relief strap from the power input module handle.
CAUTION: Avoid tight bend radii to prevent damaging the internal wires of a power cord or a
server cable. Never bend power cords and server cables tight enough to cause a crease in the
sheathing.
To Next Page
Loading...
