Operations 20
Extend the front drive cages out of the chassis
The front drive cages are secured to the chassis by shipping screws upon product delivery. The location
and number of these shipping screws depend on how the server was shipped during product delivery.
Remove these shipping screws before extending the front drive cages for the first time.
• For a server that was already mounted on a rack during product delivery, there are two screws
located on the rack ears. Do the following to remove these screws:
a. If installed, remove the security bezel (on page 19).
b. Remove the shipping screws on the rack ears.
• For a server that was delivered in a shipping carton, the shipping screws should have been removed
before the server was first installed in the rack. See "Removing the shipping screws from the front
drive cages (on page 44)."
WARNING: To reduce the risk of personal injury or damage to the equipment, adequately
stabilize the rack before extending a component outside the rack. Extend only one component
at a time. A rack may become unstable if more than one component is extended.
To Next Page
Loading...
Need help?
General