Operations 37
For more information on these cabling requirements, see the documentation that ships with the
option.
4. Install the access panel (on page 30).
5. Install the server into the rack (on page 45).
6. Power up the server (on page 19).
Remove a rear drive cage
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the internal system
components to cool before touching them.
CAUTION: To prevent damage to electrical components, take the appropriate anti-static
precautions before beginning any installation, removal, or replacement procedure. Improper
grounding can cause electrostatic discharge.
To remove the component:
1. Power down the server (on page 19).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack (on page 28).
4. Remove the access panel (on page 29).
5. Disconnect all cables from the drive backplane.
6. Remove the rear drive cage:
o Four-bay LFF hot-plug rear drive cage removal
To Next Page
Loading...
Need help?
General