Hardware options installation 122
Dedicated iLO management module option
For more information about product features, specifications, options, configurations, and compatibility,
see the product QuickSpecs on the Hewlett Packard Enterprise website (http://www.hpe.com/info/qs).
CAUTION: To prevent damage to electrical components, properly ground the server before
beginning any installation procedure. Improper grounding can cause ESD.
To install the component:
1. Power down the server (on page 19).
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Remove the server from the rack (on page 28).
4. Remove the access panel (on page 29).
5. If installed, remove the rear drive cage ("Remove a rear drive cage" on page 37).
6. Push the dedicated iLO management module blank out of the rear panel.
To Next Page
Loading...
Need help?
General