HP Apollo 4200 Gen9 User Manual

Operations 30
4.
Slide the access panel toward the rear of the server, then lift it from the server.
Turn the access panel over to locate the HPE Apollo 4200 Gen9 Server hood label. This label provides
convenient access to component identification, LED status indicators, and system maintenance switch
settings information.
Install the access panel
1. Place the access panel on top of the chassis, and then insert the tabs into the corresponding slots on
the chassis.
2. Use a screwdriver to tighten the access panel screws.
Remove the air baffle
To remove the component:
1. Power down the server (on page 19).
2. Remove the server from the rack (on page 28).

HP Apollo 4200 Gen9 Specifications

General

Brand	HP
Model	Apollo 4200 Gen9
Category	Server
Language	English