Hardware options installation 137
4.
To set the TPM operational state:
o If TPM 1.2 is installed, then select No Action, Enable, Disable, or Clear.
o If TPM 2.0 is installed, then select No Action or Clear.
5. Select Visible to set the TPM Visibility, if necessary.
6. Press the F10 key to save your selection.
7. When prompted to save the change in System Utilities, press the Y key.
8. Press the ESC key to exit System Utilities. Then, press the Enter key when prompted to reboot the
server.
The server then reboots a second time without user input. During this reboot, the TPM setting
becomes effective.
9. Enable TPM functionality in the OS, such as Microsoft Windows BitLocker or measured boot.
For more information on adjusting TPM usage in BitLocker, see the Microsoft website
(http://support.microsoft.com/).
For more information on UEFI System Utilities, see the UEFI System Utilities User Guide in the UEFI
Information Library (http://www.hpe.com/info/ProLiantUEFI/docs).
To Next Page
Loading...
Need help?
General