HP Armada 7300 - Page 83

9-6 Installing and Removing an Expansion Board
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 3:27 PM
Part Number: 203118-001 File name: Ch09.doc
Inserting the Expansion Board
To insert the expansion board onto the input/output (I/O)
assembly, follow these steps:
1. There are four expansion board connectors.
■
If you have removed the top slot cover, you can insert the
expansion board into one of the two top expansion board
slot connectors
1
and
2
.
■
If you have removed the bottom slot cover, you can insert
the expansion board into one of the two bottom expansion
board slot connectors
3
and
4
.
■
Select the connector within a slot that matches the
connectors on the expansion board. For example, insert a
PCI expansion board into slot connector
1
or
3
; insert
an ISA expansion board into slot connector
2
or
4
.
Identifying the Expansion Board Connectors
NOTE
: The top expansion board slot comprises two connectors,
1
and
2
. The bottom slot comprises connectors
3
and
4
. Only one
expansion board can be installed per slot. If you are installing an
expansion board in the top slot, use connector
1
or
2
. If you are
installing an expansion board in the bottom slot, use connector
3
or 4
.