Installing and Removing an Expansion Board 9-7
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 3:27 PM
Part Number: 203118-001 File name: Ch09.doc
2. Align the bracket
1
on the left side of the expansion board
with the tabs
2
on the slot cover. If you are installing a full-
length expansion board, align the edge of the board opposite
the slot cover chassis
3
with the appropriate alignment rail
4
.
Aligning an Expansion Board Bracket with the Tabs on an Expansion Slot Cover Chassis
3. Push the expansion board straight into the expansion board
slot until it is seated.
4. Fasten the expansion board bracket to the expansion board
chassis with the screw
5
that you removed from the expansion
board slot cover.
To Next Page
Loading...
