10-8 Installing and Removing a Half-Height Bay Device
Writer: Karen Williams Saved by: Karen Williams Saved date: 01/24/98 6:40 PM
Part Number: 203118-001 File name: Ch10.doc
3. Lift the drive cage out of the expansion base.
Removing the Drive Cage from the Desktop Expansion Base
Inserting the Half-Height Drive into the Drive Cage
To insert the drive into the drive cage, follow these steps:
1. Remove the half-height bay blank bezel by pressing lightly in
its center as you pull its edges away from the drive cage.
NOTE:
Retain this bezel. You will need it if you ever remove
and do not replace the half-height drive that you are installing.
Removing the Half-Height Bay Blank Bezel from the Drive Cage
To Next Page
Loading...
